Windows xp line in volume

When an error is thrown, this parameter specifies that Diskpart continue to process commands as if the error didn't occur.

Without the noerr parameter, an error causes Diskpart to exit with an error code. When the extend command is complete, you should receive a message that states that Diskpart successfully extended the volume.

The new space should be added to the existing drive while maintaining the data on the volume. You can extend only simple volumes that were created after the disk was upgraded to Dynamic disk.

If you try to extend a simple volume on a Dynamic disk that was originally created on a Basic disk, you receive the following error message. This restriction was removed in Windows Server Skip to main content. This browser is no longer supported. Download Microsoft Edge More info. Contents Exit focus mode. The sound coming out of my speakers is the correct volume, where as the recording volume is way lower.

The problem is with Vista or my sound card drivers, I just can't figure out what. I've already done everything there. Everything is enabled, everything is set, everything is updated. I think I might buy more Vista compatible sound card. There hasn't been new drivers for my current sound card since just before Vista was released :.

I turned up the recording volume for my Stereo Mix device and the volume is normal now. I have no idea why. Why that volume would affect Line-in is beyond me. But it works now. Search In. Problem with Line-in recording volume.

Share More sharing options Followers 0. But the most important reason to master the command line administrative utilities, such as DiskPart, is the ability to write scripts that can automate tasks.

For example, you might want to create a script to be used during an unattended setup to partition the disk and create additional volumes on the system only the boot volume is normally created during the unattended setup process.

Tip Even if you use the noerr parameter, DiskPart will still give you an error message if you get the command syntax wrong. The objects that can be managed by the DiskPart utility are disk objects: disks, partitions, and volumes. Tip DiskPart was also available for Windows , but it was not installed by default. You had to download it as part of the Resource Kit. Using DiskPart The first step in using DiskPart is to list the available disk objects and then select one on which to focus.

First, use the list disk command to select the disk on which you want to work assuming you have more than one physical disk installed in the computer , and then use the list partition command to see the partitions on that disk and select one. You can also use the list volume command to see the volumes on all the disks. This does not tell you which physical disk each volume is on.