Disk management windows nt

At the bottom of the window is a status bar that provides basic information about the partitions. A color-coded legend on top of the status bar shows what the different partition colors and patterns represent, as shown in Figure A. Figure A A color-coded legend tells you what the partition colors and patterns represent. Figure B Use this dialog box to specify the region display. Figure C You may specify a volume label, although this step is optional. Editor's Picks.

The best programming languages to learn in Check for Log4j vulnerabilities with this simple-to-use script. TasksBoard is the kanban interface for Google Tasks you've been waiting for. It takes a minimum of four disks to implement this configuration. Generally, all drives perform well in early life and in the absence of error conditions. While drive selection is crucial to reliability, this important decision is based too often on cost. It allows you to create partitions, extend partitions, format drives, create stripe sets, create stripe sets with parity, create mirror sets, create and extend volume sets, and assign drive letters.

Your version of Disk Administrator should look similar to the one that appears in Figure A. It will show all of your physical hard drives and the partitions on each. You can set up Disk Administrator to use colors or patterns in order to identify different disk strategies. Figure A Your Disk Administrator should show all of your physical hard drives and partitions.

Figure B The logical drive view will appear in the Configuration Utility. Figure C The physical drive view will also appear. Figure D The Controller Settings screen allows you to select several options. Figure E The Operating System selection optimizes several parts of each logical drive. Figure F You can expand the array and assign drives to the current stripe set graphically.

Editor's Picks. The best programming languages to learn in Check for Log4j vulnerabilities with this simple-to-use script. TasksBoard is the kanban interface for Google Tasks you've been waiting for. Paging Zefram Cochrane: Humans have figured out how to make a warp bubble. Show Comments. Hide Comments. My Profile Log out. Join Discussion. Add your Comment.

The procedure below assumes that you have installed the new hard drive correctly, and that it is set up as the slave drive i. See the documentation that came with your new hard drive for instructions on how to install and configure the drive physically. Note: New hard drives will often come with disk management software. The first hard drive should be set up as master. Consult your hard drive documentation about the jumper settings. Drives can be configured as master, slave, or only drive.

If a drive occupies an IDE channel by itself some computers can have more than one IDE channel , it should be set up as an only drive. If there are two drives on an IDE channel, one must be set as master, the other as slave.

Only the master can be the boot disk. You must tell the computer that a new hard drive has been added. In most cases, as the computer boots, it will prompt you to press a certain key or key combination to get into the CMOS. Upon starting the computer, press the appropriate key when prompted to enter the CMOS setup program.

All of them have a screen where you can set drive parameters. Most current CMOS setup programs can auto-detect the hard drive's geometry, so you usually will not have to input the drive parameters cylinders, heads, and sectors.

If you are installing a drive larger than MB, make sure that LBA or Large mode is turned on before you do the auto-detect. You may not have to set this option on newer computers. However, if you have an older motherboard that does not support LBA mode, you may not be able to use all of the space on the drive. After entering the necessary information or allowing auto-detect, exit the CMOS setup and allow the computer to boot from the old hard drive which is set as master.

Remember, since modern applications and operating systems consist of a large number of small files, a large minimum cluster size can waste a significant amount of hard drive space.